Bogdan Kecman

using 500R pot hooked to hotend sensor connector instead of pt100 (disconnect hotend completely) dialed around 200R and you don't even need to waste energy heating the hotend for the...

@etet100 why don't you look at already existing cpumod board with nxp that runs smoothieware, marlin is crap, this is way better solution, the board already exist, you can improve...

well the latest version of "studio" software support import of the g-code so you in theory can use original electronics with any of the g-code generators (craftware, s3d, slic3r, cura...)...

never tried it myself (gcode import) as it was added way after i replaced the board tinyfab is nothing special, it's smoothieware that's awesome

any way of easily checking if one has "newer" or "older" cpu, and how to check on mcu what it is? (to test if it's really TM4C1233H6PZ if they have...

> I'd really love to retrofit a bed levelling sensor to it (there's an unused fan port which potentially means a spare GPIO pin). where did you find "unused fan...



> You don't mean the *.ROM files do you? Those are just printing parameters rather than firmware. I do :( .. I thought those are firmware, wasn't really looking at...

you are right, there are "fan5" and "fan6" connectors on the up plus 2 board :) need to trace them to see on what pins they are :D I do...