archimede

Teacup not setting Y-MAX correctly after homing against the Y-Max-Switch

13

HI I have setup my Hardware (644P,20MHz) for an old RapMan 3.2. Until now it seems that most is working fine.... The only thing is, that if the print head...

Since my 4-bit-parallel-LCD display is conected on a front panel I noticed, that if the display was not connected Teacup did not start. This happend also when I did some...

G0 is always at max X speed!

1

Hi My bid 3D printer was working just fine since we correctet the overflow issue. But it it was verry noisy! So i tried to change the microsteps (that needs...