arcaine2

Hmm, i see. It has to be a mouse, but it's made to control another Android device so that's something since cursor always lands in the middle of the screen...

Ok, found the real mistake. I basically copied the same code i used for sending keyboard events. It worked when coordinates were on 5th and 6th byte for some reason,...

Semi worked on mine with I9300XXUGND5 sboot. I get: ``` ./exploit/sboot_exploit.py --shellcode shellcode/write_fw.bin -e ../../VTU00M_rev_0xFC.bin [+] Shellcode started [*] Found MMC device address [*] Rebooted eMMC into bootrom mode [*]...

A bit, compared to earlier version that worked only with XXELLA but not by much. I also think that i bricked it by unplugging the phone while it was on...

> This could also be an alternative for I9300 with a wrong sboot installed. If your device is working you can just flash XXELLA sboot with Odin and it'll be...

Have you tried current version of shellcode? I noticed there were some changes made to "heuristic find mmc_dev address". I haven't got much time to try this myself just yet.

In general, for exploit to work you need XXELLA boot (it's an old boootloader from 4.1.2 based firmware). This will work if you still have a working phone and want...

You don't have to remove the screen from the frame. Display flex is long enough for this to work. It's a bit tricky, but can be done with screen still...

Heuristics doesn't seem to work for N7100XXDME6. I have a device that doesn't boot at all without microSD. I flashed XXDME6 to SD so the phone enters download mode but...