arcadeperfect
arcadeperfect
Unfortunately not. Had tried that and it does load the package manager but it says the assets from the package are already in the project, even though they're not.
That worked thanks!
No, didn't figure it out! I tried all three settings on all three motors, ie $1pm=0 $1pm=1 $1pm=2 $1pm=3 $2pm=0 and so on. In all cases, the motors were permanently...
Hi, I checked and the enable pin behaves as expected. That is to say high when the motor is expected to be disabled, low when motor is expected to be...
I just realised that the enable pins aren't even wired into the gshield PCB. Does this mean the [gshield](https://synthetos.myshopify.com/products/gshield-v5) doesn't support disabling motors?
As far as I can see it turns out that GRBL uses one global pin to disable all motors, whereas tinyG can disable them individually and uses pins that are...
Ok I looked in the source code and it seems the version on github has this option but the version on pip does not. So I second the previous request...
I had a go at fixing the python bugs too and as with ffurrer the errors went away but the result is all glitched out. A similar thing happened when...