Andrew Lindh
Andrew Lindh
I actually have paid contracting work this summer so I have been busy. The network coding/testing is not a problem. I have real hardware for testing so I can debug...
PR submitted for new IGC and r8125 drivers. It should be plug and play for the XCP 8.2 build (and 8.3, I think). -- Andrew Lindh ***@***.*** NETPLEX 860-233-1111 Quoting...
Removing the "updated" vendor drivers on the standard 8.2/8.3 install and using the kernel drivers resolved the issue for me. ``` # yum remove qlogic-netxtreme2-alt # rpm -e --nodeps qlogic-netxtreme2...
I have basically the same results. I can access the data manually. As XO on Debian 11 is not using LVM there are no name conflicts. **Expose VHD disk as...
Not using LVM for XO helps resolve a possible name conflict, but it does not resolve restore failure.
This would be great....But, what if the ground between two pads is very far away? I think that would cause some issues in some cases.
Changing the port works just fine. Both on the proxy side and the XO side. I'm using port 4443 now.
On XO, for the ***Proxies*** page the ***Address*** is just ***remote.site.com:4443***. Same idea for the ***Servers*** setting ***HTTP proxy URL*** is ***https://[email protected]:4443/*** In your ***xo-install.cfg*** I just use ***PORT="4443"*** and...
I have the same endless fanout run problem for the current version (v2.1.0). Since it's an optional step it should have a limit to stop an endless run even if...
Now it's working again.... I'll try to reproduce it...