amv101

I am also getting this error on my Delta printer with ERCF. I didnt have this error until I installed the ERCF system on my Klipper powered Delta just this...

Had a chance to work on my new Delta with the ERCF 1.1 and attach the klippy log with the error. I get the "Timer too close" error consistently if...

There is definitely something up with that setting. From some searching, it has something to do with the probe offsets and the mesh possibly. My Delta has a print radius...

> Are you using the pause and resume macros specifically for ERCF? Yes... I run the "pause" command from the Octoprint terminal.

> > > Are you using the pause and resume macros specifically for ERCF? > > > > > > Yes... I run the "pause" command from the Octoprint terminal....

> The "ercf compatible" pause and resume macros are in the "client_macros.cfg" file on the ercf repo (klipper file folder). > > Those are the one you need to use...

> Hello. Have you read ERCF FAQ? Looks like it has been updated since I have last checked. I see there might be a timing issue. I will check that...

> > > Hello. Have you read ERCF FAQ? > > > > > > Looks like it has been updated since I have last checked. I see there might...

> Hi! Your down angle is too "high", i.e. it goes too far. You want the down angle to set the servo arm in a "vertical" position, kind of like...

> Here are two videos of the servo engaging on of the top hats. As you can seen in both videos it slides a bit back, although in one less...