alexborro

Nope.. you need to remove and configure it again.

Any update in this issue? Currently I have a proper setup but the forecast graph is shifted around 4h to the right: 

I found my issue. My azimute was wrong. My panels are facing SE but my azimute was SW (it was 225 and should be 135). Very easy to confuse if...

Hi @Caros2017 , yes, it is possible to implement this feature. As soon as I get my PR https://github.com/esphome/esphome/pull/6116 merged, I will implement it.

Hi Jonathan, you can use this adapter for M3 nuts: http://www.thingiverse.com/thing:167206 Best Regards

In my case, M4 bolts didn't fit in the original holes. Instead of re-drill all the holes, I chose to use this plastic adapter.. but both are valid solutions, it...

Check out this table: http://bit.ly/187Bo94 All bolts, nuts and rods for Graber I3 2013/11/1 7harry [email protected] > to continue this discussion - I understand that the whole frame is >...

Hi @jesserockz , could you please check if this PR is good to be merged ? It is lingering here for a few weeks. And it also fixes some reported...

Hi @jesserockz , could you please check if this PR is good enough for the next release ? It is lingering here for weeks. It also fixes some issues so...