aeridus

Results 3 comments of aeridus

Parameters not applied at boot, nor at print start with PI4 and Logitech C920

I'm getting the same exact issue, with OctoPrint Version 1.6.0 and Octolapse Version 0.4.1. I have a C920S. Any time the Pi reboots, the settings do not apply either on...

Parameters not applied at boot, nor at print start with PI4 and Logitech C920

It does seem like focus is properly retained when it's just OctoPrint restarting, so the issue is specific to the Pi 4 rebooting.

Parameters not applied at boot, nor at print start with PI4 and Logitech C920

> So, my initial testing went OK on the pi 4. I think there must be a firmware change on newer c920s, so I'll just need a copy of input.json...