Adrian Schlatter

Metric Trapezoidal Thread: TR

5

Add TR-thread. A good starting point (thread specs including tolerances) is [here.](https://mdmetric.com/tech/thddat16.htm).

32-UN-7/8, -15/16, and -1 are missing from design/UIS_thread.csv and therefore also from THREAD_TABLE.scad.

Write code of conduct

British Thread - Coarse Pitch: BSW

1

Add BSW threads. A good starting point is probably [here](http://mdmetric.com/tech/thddat8.htm) though tolerances are missing.

British Thread - Fine Pitch: BSF

1

Add BSF threads. A good starting point is probably [here](http://mdmetric.com/tech/thddat8.htm) though tolerances are missing.

British Thread - Miniature Series: BA

1

Add BSF threads. A good starting point is probably [here](http://mdmetric.com/tech/thddat8.htm) though tolerances are missing.

Matching pitch of internal and external threads

1

Extend [tests/test_table.awk](https://github.com/adrianschlatter/threadlib/blob/develop/tests/test_table.awk) to verify that each internal thread has identical pitch as its external counterpart.

Collision Test

3

Find a way to test for collisions between nut and corresponding bolt. **Idea** Render a nut and bolt combination (example: [tests/test.scad](https://github.com/adrianschlatter/threadlib/blob/master/tests/test.scad)). Use “number of volumes” that OpenSCAD shows after rendering:...

Multiple thread starts

3

threadlib currently does not support multiple thread starts but it would be nice to add the capability. This would enable the addition of PCF-33P-1 thread (#26, #27). Most probably there...

iPadOS: Wheel Pickers Dead

3

### Steps To Reproduce 1. Open Bitwarden App on iPad 2. Tap "+" in upper right corner to create new entry 3. Tap "Type" field => wheel picker appears 4....