adrian-vlad

Hi, I had the same issue. The problem was that the code was not selecting the correct input for the second sensor and it remained blocked in the CALIBRATE loop....

Also, you need to set the correct LED pins and set the correct SWITCH pins or adapt the code to do what you need when the sensors are touched. I'm...

I made a modification for that also. I checked if the lights are constantly changing when keeping the sensor pressed and it did, but only for a couple of seconds....

Yes. What I had in mind were those scenarios for setting embedded devices that tell you to hold the button pressed for X amount of seconds.

Hi, you said it worked before > with the change it works > if I press longer than 2 sec switch it off again I've made a fork where I...

Why would you need them very fast? Are you strobing the lights?

Hi, I don't know exactly what the problem is. I have made some tests with one 2gang switch and I modified the code, but I don't have it in "production"....

Yes, CHECK_SW and CALIBRATE