Adam Urban

#155 Initial arm support

1

First pass at adding arm support. Expects chromium to be installed at `/usr/bin/chromium` (Which a normal installation should be, eg from `sudo apt-get install chromium` on a raspberry pi running...

New lock codes show up in ozwadmin but not in MQTT until ozwdaemon restarted

3

New lock codes show up in ozwadmin but not in MQTT until ozwdaemon is restarted. Lock codes are being set via `ozw.set_usercode` in Home Assistant's Developer Tools -> Services. Additionally,...

Manual override settings always revert?

12

If I manually adjust the temperature via home assistant or on the thermostat itself, it always reverts to whatever the “scheduled” preset was after a few seconds. This has been...