Aleksander Bajkowski
Aleksander Bajkowski
@ThatMishakov I think the best approach is to use DSA driver[1]. Patch for xrx300 and xrx330 has been accepted upstream[2]. Driver performance comparison on xRX200: ~~~ Test OpenWRT driver DSA...
> Hello. It looks like I've been getting those errors because I didn't apply the patches from #3085 properly, but now after doing that, I am getting > > ```...
> > > > > This is the error that I'm getting on the bootup now: > > > `[ 11.383864] gswip 1e108000.switch: dsa switch register failed: -517` > >...
> @abajk I had just rebased to the latest main master, and the interrupts still hang after a few seconds of iperf3 with no errors. Might new tx-burst-length be related...
@hollyclergyman Which version of OpenWRT are you using? This bug has been fixed in the commit https://github.com/openwrt/openwrt/commit/3342d574be08db8926273678291497769d2365e9
[Here](https://forum.openwrt.org/t/openwrt-21-02-0-second-release-candidate/98026/120) it is mentioned that: `LAN ports are not configured propley For example LAN 1 is LAN 4 and LAN4 is LAN1...` This conflicts with your description of the ports.
Packet loss happens over wired or wireless connectivity?
I only have ALL0333CJ, but I accidentally erased the NAND flash on it. I only remember that 18.06 worked, later versions I have not tested.
Maybe the dgn1000b only works if the switch is programmed by u-boot. Should I mark this device broken?
I have similar feelings about ase. On the other hand it would be good to get rid of swconfig drivers where they are not needed. Only 19 of the 90...