ZeyHex

The timings don't match, it's true, but there is an overlapping range for all of them that works. It is this range and durations that are used in the library...

Hello! This is exactly my case, I have a Creality K1, where the level sensor is located on the MCU, and the motors are on another MCU. I updated Klipper...

I have not used and do not use z_offset. After removing this change, the defect disappeared. so I'm not sure if it's necessary if you initially use z_offset. I don't...

I didn't really understand what was required of me. I don't expect anything from PR, it's just a bug fix.

Thanks for the tip! Done.