XlashDev

Commenting here in case someone encounters this again with nrf52DK. libdeps can be installed via library manager. I'm using S132. > [env:nrf52_dk] >platform = nordicnrf52 board = nrf52_dk framework =...

I'm using the nrf52 dk and transferred to E73-2G4M04S1B with the same board nrf52 dk selected to follow the pattern of pins from the nrf52dk. Tried to use analogReference(EXTERNAL) but...

Hello fanoush, yeah PAH8001 has already an engine built in so you just fetch the data. But with this HRS3300 only the raw values are stored on register. I misunderstood...

I'm using a B57 Smart bracelet https://www.amazon.com/Smart-Waterproof-smartwatch-Multiple-Wearable/dp/B07LB1VR1J I can access all parts including the accelerometer raw values at this moment. With the HRS3300 I had written already a library to...

I have closed the device so I have no access to the serial UART port currently. Im debugging thru the ble UART. I'll try later this night with larger screen...

Here are some screenshots at 3ms interval. Lower than that I get some packet loss. Some looks like a pulse signal to me.  

So that what's missing with that library. Tested your library just now atc1441. This is good, haven't compared the BP yet with another smart band but by quick test I...

> The timing is quite importand, so you need to pull at exactly 40ms or another value, but everytime the same persiod. Ok noted on this. I added that line...

Hello @rubensx , I am on the same dilemma right now. How was your end result? I'm using teensy 3.2 and this circuit to interface with the k-line. https://www.instructables.com/Low-Cost-OBD2-Communications-on-K-line-ISO-9141-2-/ I...

Check if the pinouts are the same, like the UART ports, LED pin, etc. There is an schematic on the main page of this repo. If all good then you...