Voron-Trident
Voron-Trident copied to clipboard
VoronDesign
Voron Trident CoreXY 3D Printer design
Hi, I am assembling a Trident 300, is it possible that the suggested 175mm spacing for the F-extrusion should be 25mm more when assembling a Trident 300?  Just like...
Link says docs.vorondesign.com, link goes to this repository. Suggested link: https://docs.vorondesign.com/build/electrical/#trident 
The knurled nut/thumb screw for the bed on the manual says M4 (and thats what has come in the kit) But every other part (screws/tnuts etc) are all M3 and...
The tip for mounting IGUS chains has the word 'mounting' crossing over into the image, should be room if it is moved to the second line? 
After I discussed my bedmesh in discord someone mentioned that only one screw should be tight and the rest rather loose. This should be written in the manual. I followed...
Manual page 158 refers to the spacers as Thumb Bolts. I don't think this is accurate, I think they should be referred to as "thumb nuts" or "knurled nuts". This...
If you're looking into the plug end of the mains inlet wiring, ground tang up, "neutral" is on the left and "line" is on the right. see: https://www.electronics2000.co.uk/pin-out/iec.php (IEC 63020...
mini12864 hinge piece is an accent piece per the [a] in the STL filename. It should get a Voron heart in the manual (Page 274).
"... skip the wire cover and follow the instructions on page 174." Should be: "... skip the wire cover and follow the instructions on page 190."
Manual shows and specifies Foam Tape 1mm (back and top panels) and 3mm (side panels) Not in the BOM. I admit that this is a minor nit, but I can't...