Voron-Trident
Voron-Trident copied to clipboard
VoronDesign
Voron Trident CoreXY 3D Printer design
For those of us with aging eyes the grey & light blue on a white background in the pdf is hard enough to read on a screen and effectively impossible...
Page 17 calls to use Extrusion E as a spacer. Extrusion E is horizontal and spec-dependent. It is OK on 250 spec, as the E has 330mm, but on 300...
There is an inconsistency between the labels and order of removing jumpers from the board and installing the needed ones. Page 203 covers removing jumpers in this order 1. Driver...
No washer is shown in the drawing on page 142 for attaching the thermal fuse. If no washer is used you are very likely to destroy the thermal fuse with...
After asking some questions on the discord I discovered when installing the bottom panel, there should be VHB applied to the panel clips not just the hinges. The manual only...
r/VORONDesign is currently a private sub. Please consider removing it from the docs and leading users to a more relevant place.
page 98 of the manual (X axis) still has artwork and directions for the Afterburner carriage instead of the parts (and extra heat sets) for Stealthburner and Clockwork 2
"provided the following prwint guidelines for you" prwint should be spelled print Incidentally, where is the source for this? I wasn't able to find it, or I would have provided...
Page 119 In the middle of the page is a URL address about CoreXY that is formatted as a link, and hovering over the text in the Edge browser PDF...
The recommended screw to attache the wire cover on the A Drive is too small. Maybe a M3x10 instead of a M3x8 SHCS would be the right choice (page 261...
