Voron-Trident icon indicating copy to clipboard operation
Voron-Trident copied to clipboard

Published 20 hours ago • verified publisher icon VoronDesign

Screw used the wire cover on the A Drive is too short.

Open marcellomaia opened this issue 2 years ago • 4 comments

The recommended screw to attache the wire cover on the A Drive is too small. Maybe a M3x10 instead of a M3x8 SHCS would be the right choice (page 261 of the manual).

marcellomaia avatar Dec 26 '22 18:12 marcellomaia

Capture 8mm screws seem to be of adequate length...

if your foam tape is thicker than 1mm that may be your issue?

nemgrea avatar Dec 27 '22 19:12 nemgrea

I believe you did not understand the part I'm referring to. I'm talking about the screw marked below, the one the secures the wire cover on the A drive. The distance between the base of the screw to the top of the A drive is 7mm, so an 8mm screw I believe is not appropriate.

screw_wire_cover

screw_wire_cover_2

marcellomaia avatar Dec 27 '22 20:12 marcellomaia

Capture page 225 it looks like then

nemgrea avatar Dec 27 '22 20:12 nemgrea

Current revision has the error on page 231. M3x8 did not fit, M3x12 did fit.

afbeelding

atoomnetmarc avatar Oct 13 '23 23:10 atoomnetmarc