Volcano339
Volcano339
I tried it without the T_* pins and it seemed to not have any problems. I made sure that all connections were correct and I set the SPI speed to...
I tried it with USB power and connected the backlight to a 3.3V pin (with the 110Ohm resistor) and it made no difference. I might just have to get a...
Thanks for the help! I guess I'll just get a replacement. There is something that is still bothering me though. If the issue really is on the hardware side, why...
Now I have to figure out if the problem lies with the display itself or if my wiring is just not good. Unfortunately, results from testing are horribly inconsistent. One...
Alright, I got a replacement display and I still have the exact same issues. I tried using the alternate pins, but the problem persists (with USB power). The only thing...
I moved the display to the other half of the breadboard and it still has problems. The SPI speed is set to 10Mhz and all wires are
I don't think the program itself has ever frozen. It seems to work now without touch_irq connected. I tried connecting touch_irq to pin 28, but it has the same issues....
Sorry for the wait. It looks like the issue still happens if touch_irq is connected, even when `TOUCH_IRQ` is set to 255. Here is the output of `printStats()` during the...
I think it might be important to note that not every touch will break the display. There seems to be a specific spot where it will be most likely to...
Is there anything else I can try, or do I just have to accept the additional SPI transactions?