Tomer Abramovich

I found a good spot to tap into the SPI, there are 4 resistors close to the edge of the board beside the SX1276 chip:   I checked the...

A small update, I finally got the new logic analyzer so I'm able to continue working on this. If anyone's interested, I've uploaded the code for translating logic analyzer captured...

I'm currently in the process of writing an initial code for the stm32 based multi-protocol module. I've set up and radio and everything, I just have a hard time to...

Another update, I managed to get a initial working firmware that can bind and send channel data: https://youtu.be/HzVBL_GIwPI The firmware is available here: https://github.com/UnTraDe/SX1276_capture_decoder I think it's ready to start...

@pascallanger I started merging the code with the Multiprotocol firmware (checked out the latest master branch today), and I got a basic version working (only 8 channels and binding) :...

I've just tested the code from the master branch with your changes, and it works exactly the same as before. As for the upper 8 channels, I think it works...

@rodrigosclosa I don't mind doing it myself. But it looks like there going to be a lot of shuffling required to fit an RFM95 module in the existing design, so...

@pascallanger I found the bug, the loop filling the channels stopped early and missed the last 3 bytes, that's why it was 1-6 and 9-14 (2 groups of 6 channels...

@rodrigosclosa I think that the STM32 project is made using Eagle. If I remember correctly KiCad added the option to import Eagle files in KiCad 5. I also use KiCad...

@rodrigosclosa According to the data I captured from the R9M module, it seems that the only interrupt they are using is `RxDone` on DIO0. So it is only relevant for...