Yannick Richter

Same issue here with build 2022-12-18. But despite the error the software still seems to work.

Interesting. I will try to reproduce it if thats the case. On windows i can confirm that beamng works with all ffb modes and i would recommend the fast update...

The original invite from the readme should be still active. According to discord the code is still valid and not expired and i can use it. If you found an...

I am using a custom device (OpenFFBoard) that was previously used with pywinusb successfully. The sequence is to send a Output packet with ID 0xA1 and the device will reply...

The CAN presets are supposed to be defined in a separate file in the target project in Core/Src/target_config.cpp See here: https://github.com/Ultrawipf/OpenFFBoard/blob/master/Firmware/Targets/F407VG/Core/Src/cpp_target_config.cpp#L51

Keeping this open for some time until I need to update the master source branch. If there is no reply it is getting closed and a fork will remain with...

Higher throughput would be amazing. Thanks for mentioning that it might be possible. Is there anything to try in the current version? I would be happy to experiment a bit...

@pelwell Did a rpi-update and risked it and while it does seem that DMA throughput is increased significantly and takes less time to transfer, the data i receive seems pretty...

Unfortunately this does not fix the issue. The program is supposed to read 8 bit parallel data synchronized with a 5MHz clock signal at both edges from an image sensor...

It triggers the initial calibration sequence. Maybe that is not required and depending on the odrive configuration it may fall into an error state.