Smart-Robot-Car-Arduino icon indicating copy to clipboard operation
Smart-Robot-Car-Arduino copied to clipboard

Published 20 hours ago • verified publisher icon UCTRONICS

Upload issue

Open paulabitz opened this issue 6 years ago • 1 comments

I'm getting this error when trying upload. I get the same message using Windows 7 or Windows 10. I have looked a message boards and one suggestion was to push the reset at the same time as it tries to upload. I was able to get it to upload successfully once doing that trick but have not had any luck since. Anyone have any help on this issue.

I'm frustrated and my boy is frustrated...

Arduino: 1.8.8 (Windows 10), Board: "Arduino/Genuino Uno"

Sketch uses 930 bytes (2%) of program storage space. Maximum is 32256 bytes. Global variables use 9 bytes (0%) of dynamic memory, leaving 2039 bytes for local variables. Maximum is 2048 bytes. avrdude: stk500_recv(): programmer is not responding avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0xbb avrdude: stk500_recv(): programmer is not responding avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0xbb avrdude: stk500_recv(): programmer is not responding avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0xbb avrdude: stk500_recv(): programmer is not responding avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0xbb avrdude: stk500_recv(): programmer is not responding avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0xbb avrdude: stk500_recv(): programmer is not responding avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0xbb avrdude: stk500_recv(): programmer is not responding avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0xbb avrdude: stk500_recv(): programmer is not responding avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0xbb avrdude: stk500_recv(): programmer is not responding avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0xbb avrdude: stk500_recv(): programmer is not responding avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0xbb Problem uploading to board. See http://www.arduino.cc/en/Guide/Troubleshooting#upload for suggestions.

This report would have more information with "Show verbose output during compilation" option enabled in File -> Preferences.

paulabitz avatar Jan 02 '19 19:01 paulabitz

Hello paulabitz

I got the robot today and faced same issue, after troubleshooting I found that the bluetooth module should be unplugged while uploading the firmware. Also you need to make sure choosing Arduino/UNO board and the correct COM port

ahmedihmeid avatar May 27 '19 20:05 ahmedihmeid