Turtletrumpet

There are some small problems with 16.08.2, but the prints works and don't stops by error. The V16.12.x stops print after round about an hour with errors, that i haven't...

I print only with octoprint and get the 'stop' error, too. Is it a good idea to make a factory reset, after flashed the V16.12.1? The older version i used...

Clear & short: There is a problem in 16.12.1. In that Version the pint stops without useable error message. Nevertheless i love the Tinker"ware" ;). I hope the error will...

@ieol please start first and write consistent messages, who helps to find the error. At the moment you keep writing, that our feedbacks ARE INCONSISTENT. My opinion: wrong way to...

Hello, I print with Octoprint and i had today a similar problem. After 12 hours of printing the display doesn't go back to "main menu" after finished the printjob. It's...

Hello, one possible hint to find the bug in the firmware: I turn on the autooff of the LCD-display after 40 mintues. I do not use this feature before! Normally...

Hello, I compiled the 16.08.2 for U2E+ with the compiler Arduino V1.8.1. I used this [link](https://ultimaker.com/en/community/38154-how-to-build-marlin-the-way-tinkerghome-and-ultimaker-do-it-if-you-have-windows) to setup the IDE. Since 3 prints with 18 to 21 hours, the problem...

@gr5 Thank you for the recommendation! And sorry, that I have misjudged you in the past. My fault. regards, turtle

Many thanks!!! Works fine on W10 Enterprise1809 LTSC!