Turner75

HI Ryan? If you are not seeing th A - B outputs from the encoder change state when rotating slowly by hand and + 5volts and 0 volts are present...

HI Ryan Twenty dollars won't buy much encoder. A set of quality bearings for a device that has to spin long and fast might cost that. I was fortunate in...

I would suggest you have an intermittent connection problem on your display board or interface board, most likely, the display board. The fact that it sometimes occurs when you press...

Hi Further to your problem with intermittent reset. You mentioned in your last email that you have had the system installed since 2019. Has the problem started recently or has...

Hi I found that aethernet twisted pair cables work ok in a place where electrical interference is low to moderate, just listen on an am radio for an indication of...

Hi Stu Stick with it, the results are well worth the effort, and think of it as a learning experience. Cheers Graham On Sun, Nov 6, 2022, 9:07 AM stuwindsurf...

Saw this project a few weeks ago and realized what a difference it would make to threading on my ancient Drummond 1924 M4 Lathe, will remove all those exposed noisy...