Townie-au

Hi I also have the same issue

I doubt MKS will respond. It's usually the community that works the solution.

I have this issue also. Any update on this?

Hi Mark I'm also getting this error. Any ideas? [BDsensor] #sda_pin: PB1 # Don't use aliases for the board pins #scl_pin: PB0 # example of connecting to main board Creality...

I don't have a exp 1 port unfortunately. Can a USB to gpio adapter be used to connect it too?

I'm using a qidi tech X plus 3 which uses a modified MKS THR42 The board is a modified MKS SKIPR. The MKS THR has a 3d touch and Z+...

[X-6_V1.0_001_PIN.pdf](https://github.com/markniu/Bed_Distance_sensor/files/14218343/X-6_V1.0_001_PIN.pdf)

I don't get this error anymore. Was because I didn't rename the bin file correctly when flashing the MCU. Still can't get it to work though. I have both BD...

> there are capacitors in the z+- on the skipper board,so I think this modified board is also the same. are there any other pins on the modified MKS THR...

If I add a raspberry pi Pico and used the gpio on that would it work? Or last resort I could desolder the cap.