John Gibson

* [ ] The mod, firmware or slicer profile is in the correct category folder. Printable mods go to `Mercury One/`, slicer profiles go to `slicer_profiles/`. Create a subfolder with...

Unable to boot with ADXL345 connected to SPI1

1

I am having install/boot issues with my adxl345 on my Manta M8P +CB1 V1.0 I am unable to boot with the ADXL345 sensor attached to SPI1. Interestingly enough, if I...

ADXL on SPI1 will not allow boot

2

With ADXL345 connected to SPI1 the board will not boot showing error: mcu 'mcu': unable to connect Massive troubleshooting with Oliver Jean Eifler on the BTT Facebook but no resolution....