Romano
Romano
Good evening Mitch, Thank you for your advice. I got something moving, but goes with a lot of noise and sometimes back and forward. It looks as if there is...
Good evening, Spend most of the weekend figuring out what is causing the motor not to move. It goes, slow, sometimes in different directions and makes a lot of noise....
I measured the motor 2.5 ohms on both channels so that should be ok. Even put the two wires together and the motor was hard to move. Changed to a...
On 5v
And I just read it should be 3.3v. Now I have no movement at all and not change in voltage on the motor.
Do you mean the yaml file or something else? board: 6 Pack name: 6 Pack tmc_2130 stepping: engine: I2S_STREAM idle_ms: 250 pulse_us: 4 dir_delay_us: 1 disable_delay_us: 0 axes: x: steps_per_mm:...
> You could try a different motor, or swapping that motor to a different stepper. I did all of that already, no change.
I am only sending commands through the web interface, using CNCj for example doesn't work either. I connected 1 X motor on X to the 6PACK and that's it.
Ah you mean is this. Ok that is a new chapter then for me and I will attend to that tomorrow. Thank you for you help today. Time for me...
Good evening, You are totally right. This is for example what I have send to the 6PACK $J=G91 G21 F1000 X10 ok Still no movement by the way after I...