Thinkersbluff

> I have a CR-6 SR with the BTT CR6 V1 motherboard and a TFT70. > > I home Z so I can do a ABL. But I notice that...

In case this helps: https://www.youtube.com/watch?v=4xtsJ-3-c_U Around 40:20, he shows how to wire the BLTouch connectors (may involve swapping some pins in the connectors) and shows where to plug it in....

I also had the XM drive fail after 3-4 weeks. I noticed that the XM drive is the farthest from the cooling fan and all 3 motors were running hot....

> I also had this issue, after about a month of use, turned on one day and the x axis wasn't working. Also getting the TMC error. I replaced the...

Sounds familiar. X driver tends to be farthest from the cooling fan in the electronics box. Would not be surprised if the driver has failed. Get Outlook for iOS ________________________________...

I hope you have covered the 5volt pin or cut the wire from the 5volt pin on the USB cable before plugging into the USB port on the board. It...

Oh, good, although it is disappointing that you still had a driver failure, since I am using the same board. I did two other things I hoped would protect the...

> Not sure of the question as it seems unrelated to the request. I have the same question as @GerogeFu. Issues #622 (Display network status icon with a current IP...

Am I too "early" to be trying to test this on my CR6? I am able to compile Bugfix-2.1.x with [configuration files I have tailored from the 4.5.2 motherboard example...

No Joy, again CF6.1 Touchscreen Firmware complains that the "Motherboard BootLoader must be confused..." Two compile errors, with Source code from Bugfix2.1.1 branch on 5July2022, maybe irrelevant to my troubles......