TheBigFudge

Hey @cheesebox, i have the same problem. Have you figured it out yet? I know that you can pass servo=2 to calibrate to configure the outer motor --> bg.calibrate(servo=2) But...

Had the same issue, after using it a couple of months. But re-seating the OLED ribbon cable solved the issue for me :)

Hey I have the same issue, when i use the precise-listen command. where to i need to remove 'utf8'?

> It says in the error message what file and line the error occurs at. Fix that, then re-run. You will get the same error in another place. Repeat this...

is there any news? Looking forward to the update.

Same issue. Has someone a solutions to this?