Feature Request: Z-lift after Probe

[dreschpe]

After a probe, the bit is placed on top of the surface. If you touch the wrong button it is scraped over the surface. It will be nicer to have a popup request "set Z to 0 ?" after touching the surface and lift the bit 1mm after that.

Peter

[TheAntTeam]

Hi @dreschpe, we have added a feature that allows you to reset Z automatically after a probing (0193550f780e39d8153dae27a90795edae55cbfa). You can enable it from the settings panel. As for the automatic tip lift, we are thinking about whether and how to insert it as flexibly as possible.

[bvarner]

The automatic set z-position is helpful, but it's only half of the issue... I ruined a test board with a V bit that was dragged across the '0' z height across a path that didn't account for ABL.