Taudris
Results
6
comments of
Taudris
I'm having the same issue on a 3B+ and C920. I don't have a Pi/CSI camera to try.
Can this issue be added to the install documentation? Or even better, is there a way to automate handling it?
This has been screwing me over with mesh leveling. I'd measure the bed, run `SAVE_CONFIG`, then make some other config change like motor current, which because of this issue would...
I just ran into this issue myself using Dapper 2.0.123.
Any update on the stock S60 firmware? I'd love to try IronOS on mine, but I need a way to revert if it ends up not working for me.
That would be even better!