TJ-Houghton

I am having the same problem. My file is only 11MB. I find that the problem only occurs when running cncjs GUI from the PI. If I open CNCjs from...

Mitch, Thanks. I am running a Pi 4B with 4GB of RAM. Do you think getting the 8GB board would solve this problem? I bought the Pi because I wanted...

@karoria Thanks for the info. I'll take a look at them. I moved to cncjs because it could do manual tool changes and TLO calcs (using a macro) and I...

Christophe, While not ideal, it may be the way I need to go. I have been trying other gcode senders, but they all seem to have their issues. UGS sender...

@karoria - Can the esp32 webui be used with a stock Shapeoko GRBL controller? I am not really interested in changing controllers right now.

I think I had the same problem. I'm new to Raspberry Pi/Linux so I am struggling through this. I tried installing CNCjs using the instructions on the main cncjs page...

> Thanks for your input, post logs in the future some I can better debug. > What version of Raspberry Pi and OS are you running? > > I will...

Thanks. I had that downloaded and it seemed to be working...until tonight. So, I decided to reflash my SD card and will reinstall everything. :(

@AustinSaintAubin I decided to just use the Dropbox website to download files. It was much easier than trying to figure out CLI instructions. Once I reflashed my SD card CNCjs...

@AustinSaintAubin I posted on other forums and the general consensus is that somewhere are ~5-6 MB files is where the CNCjs server shuts down. I have successfully run files smaller...