Tommy Brenner
Tommy Brenner
I recommend temporarily using card-mod. Here's the base code: ``` card_mod: style: | ha-card { transform: scale(1.0,1.0) translate(0%,0%); aspect-ratio: 1 / 1; } div { transform: scale(1.0,1.0) translate(0%,0%); } ```...
Same here, but only for one my units. Using "esp32doit-devkit-v1" for both. [EDIT]: The unit that is having these issues, is apparently hardware revision V1.3 .
Just to be clear, the proxy is nowhere near any type of electronic interference, like my router of anything else that could cause issues with BT or WiFi. I've also...
> Try decreasing `interval` to, say, 550ms. Mmmm, not sure. Initially it seemed to have helped a bit, but after a while I basically got the same result. I've been...
I'm having the same issue with the built-in BT of the Raspberry Pi CM4 on my HA Yellow. [EDIT]: The issue seams to stop once I configure it to only...
+1 Luckily I decided to only update one of several remotes I own. To be clear, I use the E2001/E2002. [UPDATE] I finally got everything working again after force removing...
Mine seems to work randomly between reboots and generally tends to fix itself when I start the vacuum via the Roborock app on my phone.
OMG, when did the progress go backwards? I switched to Z2M some time ago because there where still issues with the power metering. And now switching back because of HA...
OMG, after searching for hours (!!!) online, I found a solution on a Klipper forum. This worked for me: (1) SSH into the Raspberry Pi (2) Command `sudo raspi-config` (3)...