Steven Doyle
Steven Doyle
It shouldn't overwrite these values; only known solution is to restart Then again, it's not a huge issue as for scale/phase results you can go back to the legend menu....
It's annoying to set the scale factor for each transient load step Options: 1. set scale factor classification based on result type - displacements/loads (scale factor is linked) - modes/frequency...
I'm not sure what would happen if you were to rotate the model/resize the window during the movie, but probably a bad idea.
a header of ``` $pyNastran: units=in-lb-s $pyNastran: units=m-kg-s ``` will allow units to be defined. Ideally, there'd be a menu to set defaults/change display units.
I'm not sure what to do for the rods (they're round), but the bars should be pretty easy with a shear center formula. The pshells/pcomps should be very easy, with...
Currently, only static vectors are allowed. Redo the loads to support transient data. There is no requirement for backwards compatibility, but it would be nice.
These PBEAMs are not the same PBEAM 12 6 .785398.0490874.0490874 .0980921 -.5 .5 .5 -.5 + YESA 1. + .8861762.8861775 PBEAM 12 6 .785398.0490874.0490874 .0980921 -.5 .5 .5 -.5 YESA...
The W2GJ matrix defines a camber line. You can stack the aero panels end to end and show a continuous plate. Then your aero panels will look like an airfoil.