Steve2017
Steve2017
> For sure! > > Let me know how that setup works for you. I also have the DIP 1.1 and a BLTouch - v3.1 bought from Creality. I have...
> Do you have the 2 pin plug with the white and black wires plugged into the probe port or the z axis end stop port? Plugged into the Probe...
> Another thing I noticed, the BTT website states the V1.1 comes with the STM32F103RC processor, mine have STM32F103RE's. May be work re-defining that in your platform.io file if you...
I have tried it with the BLT plugged into the Z-endstop - and have uncommented the line you mention - it will not recognise the BLT probe triggering - but...
Wiring has been checked against the 1.1 PDF many times - and is wired as you state. The fact that it tests and actually levels makes me think the wiring...
I have 2208 drivers, but about to change to 2209. Just hold off - I have changed the environment to the RE version, and have redone all the cable connections...
I have done a couple of runs this morning and it both homed and levelled on the BLT, but my offsets are wrong. I want to compare the two Config...
It’s the x & y offsets that are off at the moment- it’s going off the bed on levelling. I just need some time free to redo those & reflash.
Centre for Z-Home. I have Safe_homing defined which I believe forces it to the centre of the bed. My birthday party duties are over so I will have another shot...
The change of environment did not make a difference - BLT is still working properly... plugged into the Z-Endstop. I have not run a print job yet, but can't see...