Andrea Salvatori - IU6FZL

I have the same problem (3 hours instead of 8) with the latest version of saml2aws, using Google as Identity Provider. @MaybeOron Did you find out a solution?

> I have the same problem (3 hours instead of 8) with the latest version of saml2aws, using Google as Identity Provider. @MaybeOron Did you find out a solution? My...

> I transfered to aws sso Because you resolved the problem with AWS SSO, you can close this issue. :wave:

> Hi, im planning on using 3 anchors as well have you found a solution? Hi Leylan24, 3 anchors are supported but not in parallel. The radio protocol does not...

Hi @maeenk , You have set up two different types of configuration for radio communications (last line, Device Mode). In addition, IRQ requires a pull-down resistor to ground. Moreover, pay...

Hi @maeenk, we have been using the same MCU. Check out the [wiki](https://github.com/F-Army/arduino-dw1000-ng/wiki/Tested-hardware-boards#nodemcu-10-esp8266) to find out pins connection with NodeMCU 1.0, this seems to be an SPI or alimentation problem....

> I was wondering if you utilized an external power supply because I am simply using the connection from a usb to a computer. Or a voltage regulator; if so,...

Yes @maeenk, we have made the same connections but whitout pull-down resistor on IRQ.

Hi @maeenk , check the DEFAULT_CONFIG structs at the beginning of Arduino examples.

Yes, when all F appears at the beginning during the reading of configuration committed to the DWM1000, there is a problem with SPI communication. I had the same problems a...