SkiBikeMake VT.548
SkiBikeMake VT.548
It would be helpful to call out the process for magnet installation for the hall effect sensor on pages 50 and 109. Page 50 states "HALL EFFECT ENDSTOP? If you...
Page 118 - reference to "sensor_to_nozzle" should be revised to "end_of_bowden_to_nozzle". Reference to variable residing in ercf_software.cfg should be corrected to be ercf_parameters.cfg.
The current design provides for only 0.2mm clearance around the roller bearing in the Selector Encoder Cart Right and Left parts. Print tolerances can result in interference with the bearing....
 Design tolerance between bearing and printed part is only 0.2mm per the circled area in the attached picture. The printed part was too tight and prohibiting the bearing from...