Siress

Thank you for that information! I will give it a shot and report back. On Thu, Jan 2, 2020, 22:24 bb-qq wrote: > Since the controller chip of B07VNFLTLD is...

### **Description of the problem** Confused about how to configure the IP. Should it be listed as a DSM Network Interface? r8152-cedarview-2.12.0-1.spk is running, B07VNFLTLD is recognized per lsusb, but...

I did run the command, but it did not list eth2 after "ifconfig -a". On Fri, Jan 17, 2020, 04:41 bb-qq wrote: > Did you run ifconfig eth2 up and...

[77414.866474] usb 8-2: new SuperSpeed USB device number 3 using etxhci_hcd-170202 [77414.894713] etxhci_hcd-170202 0000:04:00.0: WARN Event TRB for slot 2 ep 2 with no TDs queued? [77414.903531] etxhci_hcd-170202 0000:04:00.0: WARN...

Also, I just ran "ifconfig eth2 up" again and received this message: "SIOCSIFFLAGS: Operation not permitted". I then elevated to root and ran it again. As root, no error message...

YES! I don't know what changed, but it now shows up as LAN3 and I can assign the IP manually. Thank you so much for your work and for helping...

Excellent, thank you. I have one more issue that I resolved myself. This is more of an FYI with a question at the end. Here's how I left my network...

After my last post, I started using the RTL as the only gateway. I changed it's IP to my default IP for the NAS and unplugged LAN1. The connection has...

I connected the PC (Tx) to RTL again for these values: DSM for LAN3 (RTL): 2500 Mbps, Full duplex, MTU 1500 Win10 for Mellanox: 10 Gbps, Jumbo Packet size of...

I found a specification sheet for the Tx I've been using. Despite what I had previously read, it is not compatible with 2.5 / 5 GBase-T. I've ordered a FS(.com)...