Shade Technik

Do you consider "The Imaging Source" in America a "Reseller"? The guys in the US have never been very knowledgeable about the technical details of your products. There used to...

Calling it the 8i20 driver is probably a misnomer rather than saying it's the SS driver, and the way it reacts to the 8i20. Believe you've seen this before, the...

I tested that version again and got the same result. I tested the 7i66 with that mk-hal version installed immediately beforehand and the 7i66 did work, the 8i20 discovered and...

If the 8i20 didn’t work my milking machine wouldn’t have a spindle. I previously took it out of testing since dragging the DE10 setup down to the mill while trying...

One question I guess worth asking is whether anyone knows a case where someone is using an 8i20 over SS in MK. It’s a rather popular drive with the LCNC...

I don't think it's mksocfpga, I think it is the SS driver in mk-hal. There's not really any reason to think the firmware built from mksocfpga is at fault considering...

Gave it a try this morning with the new MK-hal deb and it's still a no-go for the 8i20. I had to remove the 8i20 from the machine I typically...

So is the DE10 nano. I VNC into the nano over ethernet plugged into my network switch, I don't bother plugging a monitor into it usually. the 7i76e and 7i96...

Getting the DE10 setup with the 7i96 would honestly be kind of a PIA, and I'm not sure what it would prove exactly. What I could possibly do is get...

Try swapping out the sserial.h header file with the LCNC version? I see differences but they don't look like compatibility issues. [https://github.com/LinuxCNC/linuxcnc/blob/master/src/hal/drivers/mesa-hostmot2/sserial.h#L227](url)