Wilson
Wilson
Hello, I did find this problem recently, which may be caused by the long reset time of low level. Try to reduce the low level delay time (
It was the hardware design that caused some of the problems. Try further shortening the low level time by, like 0.2ms.
I have looked up some information but there is no introduction about this register. I'll try to ask the factory.
I asked the factory, they said they did not have relevant information of this register. I think it should be Boost. It is directly provided by the IC manufacturer, and...
Yes, but it might work without it. I haven't verified it. This screen is relatively old, I have not seen similar registers on other screens.
@arseniiarsenii Hi, If you only use one model screen, I think the method of @txoof can be adopted completely. by the way, 2.13inch e-Paper HAT (C) are almost out of...
Hello everyone, The problem of restarting at Pi ZERO is caused by our e-Paper Driver HAT. The hardware has been updated. Look at this #92 -------------------------------- modification: This seems to...
@pdavid-muc , Please try to use the PH2.0 8PIN interface. The current version only addresses the Pi Zero reboot issue, and other non-working issues are currently being tested.
@pdavid-muc Here are some useful information: [waveshare wiki](https://www.waveshare.com/wiki/7.5inch_e-Paper_HAT)
Hello, there is currently no official way to implement partial refresh on thie screen.