RoP09

[BUG] Adding 5th stepper in UART mode crashes firmware

18

### Description I Added a 5th stepper motor driver (TMC2209 V2.0) to my SKR Mini E3 V3 using the Marlin based FW from [Mrisoc](https://github.com/mriscoc/Ender3V2S1) . Configuring the driver in Standalone...

I recently swapped my Creality 4.2.2 on my Ender 3 V2 to a SKR Mini E3 V3. No other hardware change was done to the printer (the printer is modded...

Lumix S5 Bulb mode not working

6

**Describe the bug** I am using Gphoto as provided by the latest version of Astroberry 2.0.5 together with the Lumix S5. It seems that it is not possible to set...

Vitocal200S support / XML file configurable

14

Hello, I have a Vitocal 200S which uses a different command set (see https://github.com/openv/openv/wiki/Adressen#adressen-um-werte-abzufragen-oder-zu-setzen), which I already used successfully for years in FHEM / VCONTROL. Would it be possible to...

I newly installed this component. But somehow it only sends data over MQTT a single time after the start of the esp32. Any idea? ( Below is a log after...