Ricky1975

> Ran the sudo apt-get install from the instructions. But get ModuleNotFound when trying to start Ortho4XP pip install scikit-fmm was the missing part on my side

Has there been any solution? Because I face the same issue with the UM2 since this version. I did a factory Reset with the M502m checked e-Steps and everything else...

Due to another defect I had to replace the mainboard. Since the new board is in place, the effect is gone. Extrusion is normal and the stepper runs with the...

Same error here. But also with a fresh 1.3. I have no 1v3 with "old" height data to check with. Update (same effect for 1.3 and 1.4): Seems like someting...