Marlin

Marlin copied to clipboard

how to compile

3

When I attempt to compile there are lots of missing files. I am using win7 64 and Arduino.ide 1.5 and 1.6 to install your marlin on a melzi. Have not...

chuck787

I have a special request, is it possible to add the g-code instead of this: # define Z_PROBE_DEPLOY_START_LOCATION {0, 0, 50, 0} // X, Y, Z, E start location for...

prophetmaster

Wurstnase

Offset probe issue

1

Hi Rich, This firmware is very promising thanks for sharing, been testing it out I am facing a strange problem, when I auto calibrate, the offset probe tip shows good...

aliahsansyed

it's normal i have much vibration on calibration and print ? I have a delta

prophetmaster

target confusion

3

Hi, I was installing the Pibot IR sensor for bedleveling and that works great, however I discovered 2 very odd behaviours in the process. 1. When I initially configured my...

Sungod3000

Question: What could be causing large offsets for ox oy oz?

5

When running the G30 A command I notice 4 of the 7 measurement points are well within range after few iterations and 3 (ox, oy and oz) are way off...

jb137

Autocalibration Error - Returning -20.0000 mm when thrusting and not activating FSR

7

So, I recently build a delta printer, and am trying to use the FSR's to perform an autocalibration. I'm getting a bizarre behavior that I can't figure out. I'll post...

timrhavens

Printer gets "Hiccups" when i enable display support.

5

I don't know if this issue are on the Marlin Master 1.04 or the u8glib 1.17 (http://code.google.com/p/u8glib/wiki/u8glib) HW: Arduino-compatible Mega2560+ RAMPS 1.4 + 12864 Discount Full Graphic Smart Controller. All...

LillerLars

Auto level grid seems backwards when printing

5

This is tough to explain, but I'll try. Love the FW btw, it's awesome, just one thing I may be missing here. After a G28 command, I bring the head...

MakerFront