RexLinz

Well done project. Nice to contribute a little bit to that. Roland Am 10.02.2024 08:12 schrieb Shai Seger ***@***.***>: You are definitely correct. Thanks! — Reply to this email directly,...

Thanks richb2k. I did some tests on my desktop PC also running Windows 10 this morning (the one I reported has been from the notebook): a) On the desktop PC...

I can confirm ELMERSOLVER_STARTINFO is only required when I do not specify the name of the SIF file to process on the command line. But this does not change the...

Behavior getting even more interesting: I uninstalled and reinstalled ElmerFEM from the notebook. No change to before (the old and the new one has been 9.0, but showing a different...

While it might be irrelevant to the actual issue, I would like to start describing my workflow. My goal is to simulate a capacitive sensor setup including stray capacitance to...

> Please make sure that none of the folder names or paths have spaces. Elmersolver should tolerate spaces, but let's eliminate that as a possibility. BTW, if I remember right,...

> Your timing results do not unfortunately make sense to me. For example "echo on/off" only affects the reading phase of the model. Unless you have included a huge x/y...

> See slides 9 and 14 for motivation and pointer to test case: https://wiki.f-si.org/images/7/71/Elmerfem-fsic2024.pdf Thanks for that interesting document. There is so much information around. I'll give a try once...

> Does running the command prompt as administrator have any effect? No change in execution times. > You have probably already tried disabling any antivirus software, if so, what was...

> See slides 9 and 14 for motivation and pointer to test case: https://wiki.f-si.org/images/7/71/Elmerfem-fsic2024.pdf I experimented a little bit according to what I have found there. First of all I...