RetromanIE

17.02.1 Firmware "Error - Stopped" and another potential problem. Ultimaker 2 Extended +

20

I've had a couple of things happen since installing 17.02.1 on my Ultimaker 2 Extended + First issue i am not sure if its firmware. I've had the printer just...

Very large retraction on print completion - V19.03.1

19

What it does is at the very end of the print (once completed) it does a large retract. Its happened 3 or 4 times in the last day or two(since...

LCD reverts to normal post power up screen during prints over an hour - V16.08.2

8

This issue was happening on my Ultimaker 2 Extended, and I have now upgraded it to a Extended + and am using the + firmware and getting the same issue...

Error: Tried printing out of printing area

1

Getting the above error on the latest V16.12.1 firmware. Didn't get it on the previous version. The model i was printing was a lot smaller than my build area. gcode...