Peter

> I am planning to add one of those sensors on a canbus board and I wonder how much of an effect it will have on the canbus traffic. for...

I can confirm that this works as intended. One thing worth noting is that if `min_speed` is set to a value lower than `off_below`, the fan will be off. This...

> Does it make more sense for min_speed deafult and/or min value to be set to off_below? You will have to wait for Kevin or an official reviewer to comment....

FWIW, I am targeting the same tool head configuration using Stealthburner, Orbiter 2 & EBB36 (or alternatively EBB42). I have defined what I believe is a reasonably optimal design configuration,...

Just had another look. Placing the EBB36 orthogonally would indeed work much better and it appears to need only reasonably small changes to your original design: 1. Revised **Chain Anchor**...

Another feasibility concept with EBB42. It is awfully tight in there, and overall the "stealth" surface geometry makes it a bit challenging to work with TBH... 

> Do you uploaded your designs yet? Thank you for your comments. Note that this is only a proof of concept & fitment check and not a design. I just...

Thanks for the empirical data. I have not measured the stepper temperatures on my installation, but having interacted with Robert I also have no doubts that his data is as...

> Your solution for the fan and the cable cover looks nice, but are you cooling the motor or the board with that variant? > Perhaps you could share your...

I am attaching the cover concept STEP file in case you find it useful for positioning the fan. It also includes a 3010 fan model that I put together a...