RDS356

Feature: use the same GPIO in all axes to homing. - limit_neg_pin: gpio.xx

1

### Machine Context Simplifying the wiring. ### Feature Description Like on grbl 0.9, mach3, etc you can use the same pin to all axes to make the homing. Using all...

Feature request: spindle_up and spindle_down time delay.

5

In my though this feature must be on sender(like mach3, Bcnc, etc) and not in firmware. I also though that the working is simple; When M3 or M4 enable respective...

I want to change the state on pin coolant.M8 low level, M9 high level. Is it possible ? Thanks..

Hi ... Can I use this module to read a USB scanner barcode ?

Are the all inputs like e-stp, homming, probe, pins pullup ?

1

Not a issue, just a doubt. I'm building my board, is necessary pullups resistors on the inputs ? Thanks. Regards, Reinaldo de Souza