PurpleHullPeas

Thanks for updating it. My ultimate goal is to be able to simply point someone to the Quick-Start Guide, without any additional commentary, whenever someone asks about flashing MPMD Marlin...

@aegean-odyssey @mulcmu I like both of these suggestions. Admittedly, I have been doing all of my calibrating/printing directly over Octopi or Python, so my input here is based purely on...

@aegean-odyssey Nope. My understanding is that if Issue #25 gets added, then there will be no need for my script anymore. It could all be replaced with simple gcode files.

I am still on release 13 with a Gigdigit silent board and upgraded hot-end fan. I have to slow my fan speed down during initial heatup to avoid this error,...

Shot in the dark here, but what is your Start Gcode? Some people have gotten screwed up by using Brian's old start Gcode from the wiki which has some really...

> Should I consider replacing my thermister if `r13` isn't working? It depends. From my observations, the thermistor is the easiest to accidentally damage while working on the hot-end (seen...

My esteps are 415. I am running a 10A PSU and had to steal the connector off of the stock heater to make this work, but it works well. Otherwise,...

12V 30W is stock. I upgraded to 12V 40W because I deduced that the mosfet on the board can handle it, since the same mosfet is used for the 40W...

> Any idea what could cause the loss of power during the process? I really can't think of anything aside from a hardware malfunction as `r13`, which works for other...

> ... now I REALLY want gigdigit to get back in stock soon. Tons of stuff has been listed as "out of stock" for quite a long time on Gigdigit....