Pavel Veider

Such errors happen a lot in my case. I just repeat connection a few times and once it connects… Edit: did you set pin to access? In this case you...

When battery is replaced and settings were stores in a flash before: is it data automatically read from flash and device “just works” like before or it’s needed any action...

Hello to all! I just discovered PartKeepr and i'm testing it on my Synology. I have a question regarding this topic: Since i ran into same bug, i found out...

After some more testing i think that function as such works, it's just that checkbox doesn't reflect actual state. - if i enable above function, days appear, even if checkbox...

If you flashed pvvx FW - why do you still use original xiaomi platform? Use pvvx_thermometer, that way you don’t need bind key.

You can also use atc_thermometer platrofm, sure , if you have atc FW installed (only now i saw that it’s atc github, not pvvx, sorry).

The catch is that original FW doesn't report actual battery state - it always shows as 100% until battery is (practically) emtpy, then immediately shows "low bat". That's why your...

Huh... i think that voltage is not reported at all in original FW, only "percentage" - more or less in binary form :-) as "good" and "bad". Since i use...

Couldn't say because i don't have them for long - appr. 2-3 months now, they all show around 80-87%. For longer battery life i think that you can set a...

I think that BLE protocol has some limitations regarding publishing interval, yes. I can’t tell details, though, but i do remember something aróund 5 seconds, yes… Reset pin can be...