protocentral_max30003

protocentral_max30003 copied to clipboard

No ECG signal

5

Hi, I have bought a protocentral breakout board for MAX30003 recently and I have been struggling to get it up and running. A similar issue is occuring to me as...

stanky95

I've connected all the pin correctly. but showing Failed to read ID, please make sure all the pins are connected

Killpop666

I have been trying to get the MAX30003 chip to work with my Arduino MEGA and I have had no luck so far. The connections match the steps and I...

vlad-roz

Sporadic 20BPM then 240BPM

2

Is there a specific set of registers that allow for the cleanest data struggling to find the issue with the rtor readings coming from the MAX30003? At the moment everything...

elliotglynn1

reading speed

7

Hi! I might have a question that seems very obvious for you. But I guess I need to ask somebody. I have a hard time to figure out what the...

agentff6600

I've been having issues with acquiring a quality signal using this library and found out that calibration was set to enabled by default. This will in fact worsen the behaviour...

Tomisdebom

Hi there, I have followed the schematic diagram and have programmed the modules using Arduino Uno. However, when I open the GUI and select the port. It closes immediately and...

RbbyWyah

Noisy data and unclear .csv readings.

11

Hello, I've acquired your max30003 module and hooked up to an Arduino Uno and after several iterations I managed to get a decent Heart Rate signal. However: Even though I've...

rogzam

gui file has virus

2

i'm almost done with the project but the gui file i download is not getting downloaded as it says it has virus

harsh125

Max30003 problem with SPI

3

Hi, my project is patient Monitor I already bought max30003,afe4490,max3025 and I'm trying collect them in one arduino(mega 2025),everything is ok except when I'm connect SPI pins for max30003 and...

adelalfusail