Printrhub
Printrhub copied to clipboard
Printrbot
This is the public repository of the display and controller of our new 3D printer: Simple 2016.
G-Codes are hardcoded in the firmware (see Printr.cpp). This has issues with sending files via WiFi and for overall flexibility. As a first step we should document current G-Codes used...
The display should display the printers IP address all the time or if not possible should be easily accessibly with a tap on a button.
This could remove requirement of using the cloud firmware update page— which is difficult to use and confusing. That page could be used as a last ditch effort btw
(May not be possible), in which case, we could give instructions to not turn off screen before update begins.
Setting up the printer via touch screen only should be possible without external device support (i.e. launching a browser on your PC/Mac or smartphone to setup the printer). The currently...
We need to define when this happens. I believe it is when loading/unloading filament. But I need to go back and check.
If heatbed is activated it should heat up along the nozzle. Printing should start once both the nozzle and the heatbed have reached desired temperature. There might be printers that...
I'm using the small starter spool you ship with the printer. When a print finishes the gantry whizzes up the Z at warp speed, crashes into the spool, jams and...
When doing a USB print from Cura the printer homed correctly, and then for some reason the X axis decided to keep going right (- past home) causing the motor...
Mid way through a Cura USB print I noticed it wasn't coming out well so I clicked "Abort" in Cura, which for some reason rams the print head into the...